Gutter reattachment
Gutters are taken down and reset during the repair at the right slope.
Exterior Services
Fascia Repair New Milford, NJ
A roofer in New Milford can repair or replace rotted fascia boards, reattach sagging gutters and fix the drip edge that keeps water off the wood, once the source of the water is found. Dial (551) 374-2044 to talk with a local roofer about the fascia.
Fascia rot nearly always comes from water getting behind the gutter. Without a drip edge lapped into the gutter, runoff clings to the roof edge and wets the top of the fascia every storm. Over a few seasons the wood softens, the gutter screws lose their grip and the gutter starts to sag or pull away.
What starts as a soft board can spread well past the trim. The same water rots the ends of the rafters, the first course of roof decking and the soffit nailer. Aluminum wrap over wood can hide all of this, since the metal looks fine while the board behind it crumbles.
It helps to know what you are seeing before you call. Look for sections where the gutter tips forward, where the board looks dark or swollen and where paint is flaking. It also helps to know the fascia material and whether the gutters are original to the house.
Many fascia repair calls in New Milford also turn up a need for soffit repair or gutter installation.
Dealing with this in New Milford, NJ right now? Call (551) 374-2044 and describe the problem to a roofer who works in New Milford.
Call nowThe process
How fascia repair works
Here is how a roofer typically handles a fascia repair.
Inspect the roof edge
Before the board comes off, the roofer looks at what has been soaking it, from the shingle edge to the downspout. An awl or screwdriver finds the edges of the soft wood.
Take down the gutter
Gutters are taken down along the damaged stretch, which also shows how well the hangers were holding. Old spikes and loose hangers are not reused.
Check the rafter tails
With the fascia off, the rafter ends and the edge of the roof decking are checked for rot. New fascia nailed to rotten rafter ends will loosen again.
Install new fascia
A replacement board matched to the existing size goes up, sealed at the ends and joints. Wood is primed on every side, including cut ends, before it goes up.
Fix the edge flashing
A drip edge is added or reset so it laps over the back of the gutter and throws water clear of the fascia. Without it, the same board will rot again.
Rehang the gutter
The gutter is reattached with hangers spaced closely enough to carry water and debris. Wood fascia gets a finish coat of paint.
What is included
Fascia repairs a roofer can handle
Fascia wrapping
Metal wrap can be added over new or sound fascia with the drip edge lapped over it.
Edge flashing
New drip edge is tucked under the shingles over the gutter so water drops into the gutter.
Soft fascia
Soft wood along the roof edge is removed back to sound material with sealed joints and ends.
Framing repair
Rotted rafter ends behind the fascia are sistered or rebuilt to keep the roof edge straight.
Related service
Fascia Board Replacement New Milford, NJ
Full fascia board replacement is the right call when soft spots keep turning up along the same edge or when old boards are cracked throughout. The gutters come down, the old boards come off and the rafter tails behind them are checked before new boards go up. The choice of material affects upkeep, since wood needs paint while PVC and wrapped boards do not.
Timing fascia replacement with a reroof in New Milford lets the new drip edge and the new boards go on together. Be wary of any plan that covers rotted boards with metal instead of replacing them. The new boards should match the old width so the soffit closes properly.
Related service
Fascia Board Repair New Milford, NJ
When rot is confined to short stretches, the damaged part of the board can be cut out and a new piece scarfed in. The new piece is joined with an angled scarf joint so the seam is strong and less likely to open. Very small areas of surface rot can sometimes be treated with a wood consolidant and exterior filler, then primed and painted.
Patching a fascia board in New Milford without fixing the gutter or drip edge above it just buys a season or two. That usually means resealing a gutter seam, unclogging a downspout or adding drip edge over the repaired section. Done right, the repair is hard to spot once painted.
Local help
Fascia Repair Near Me
Fascia repair calls in New Milford come from older homes with painted wood trim and newer homes with aluminum-wrapped edges alike. Across New Milford and nearby communities including River Edge, Bergenfield, Dumont and Oradell, the fascia under trees and heavy gutter loads is the first to go, so a look along the roof edge each spring and fall helps catch soft spots early.
For fascia repair in New Milford, NJ or nearby towns like River Edge, Bergenfield, Dumont and Oradell, call (551) 374-2044 to reach a roofer who covers your street.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in New Milford, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why not wait
Smaller repairs
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Familiar with local homes
Local roofers see the same roofs and storm damage across New Milford and nearby towns.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
Fascia Repair questions
Which fascia material lasts longest?
PVC and composite fascia resist rot and hold paint well. Primed wood is easy to match on older homes but needs regular paint. No material holds up if water keeps running behind the gutter.
Why do gutters pull away from the fascia?
The fascia is what gutters are fastened to. As rot sets in, fasteners loosen and the gutter starts to droop under the weight of water and debris. Repairing the fascia and rehanging the gutter with hidden hangers fixes both problems at once.
Do I need new fascia boards or just a repair?
Spot repairs work well for rotted corners and short stretches. Long stretches of soft wood are better handled by replacing the whole board. The framing behind the fascia decides how big the job really is.
Should I cover rotted fascia with metal?
Covering rotted wood with aluminum hides the rot instead of stopping it. The gutter hangers still screw into the wood behind the wrap, so they loosen as the board softens. Fix the wood, then add wrap over it.
Why is my fascia rotting?
Most fascia rot traces back to the roof edge and the gutters. A missing drip edge, clogged gutters and leaking gutter seams all keep the wood wet after every rain. Peeling paint and unsealed cut ends speed up the damage.
More questions? Call (551) 374-2044
Other services that may help
Soffit Repair
Soffit repair for wood, vinyl and aluminum eaves, so the attic breathes and the overhang stays sealed.
Learn moreGutter Installation
Seamless gutter installation sized to the roof, pitched to the downspouts and hung on hidden hangers, from K-style aluminum to half-round and copper.
Learn moreGutter Repair
Gutter repair for leaking seams, sagging runs, loose hangers and broken downspouts, so roof water drains where it should again.
Learn moreRoof Repair
Fixing the shingles, flashing, boots and decking that let a roof down, so a sound roof keeps working for years.
Learn more
Looking for something else?
See all roofing servicesNeed fascia repair in New Milford, NJ?
Call (551) 374-2044 to talk to a roofer serving New Milford, NJ.